DuraVent 2PPS-E45 Installationsanleitung

PolyPro®Installation InstructionsPolyPro Single-Wall Gas Vent System for Category II & IV Gas-Burning Appliances

10Lochinvar 2" installation (Fig.14)1. Slide PolyPro pipe w/ PVC adapter into oblong hole and down. Brackets will point away from the wall, on

11pipe is to be installed on the exhaust outlet.3. Once securely installed to exterior, verify exhaust pipe cannot be removed from termination cap.St

128. Install gaskets into Co-Linear Adapter (if applicable). (Fig.13)9. Connect Co-Linear Adapter to termination (if applicable). (Fig.19)10. Insta

13M&G DURAVENT POLYPRO CHIMNEY CAP TERMINATIONCOMBUSTION AIR INTAKE FLEX HANGER BRACKET AND HARDWAREAIR INTAKE FLEXFLEX CLAMPM&G DURAVENT POL

THIS PAGE INTENTIONALLY LEFT BLANK

THIS PAGE INTENTIONALLY LEFT BLANK

PolyPro® is a registered trademark of M&G DuraVent, Inc.All rights reserved, ©2014 M&G DuraVent is a member of M&G Group. Customer Servic

A MAJOR CAUSE OF VENT RELATED FIRES IS FAILURE TO MAINTAIN REQUIRED CLEARANCES (AIR SPACES) TO COMBUSTIBLE MATERIALS. IT IS OF THE UTMOST IMPORTANCE

3PolyPro Single-Wall Gas Vent SystemFor the most up-to-date installation instructions, see www.duravent.comPolyPro®CONTENTSLISTING. . . . . . . . . .

4LISTINGListed to ULC S636 Rated Class IIA, IIB, and IIC vent systemmaximum temperature 230°F (110 °C)maximum positive pressure 15 in-w.c. Massachuset

5IMPORTANTTo prevent possible recirculation of ue gases, the installer must consider the eects of prevailing wind conditions, eddy zones, nearby bu

Figure 2PUSH DOWN TO LOCKPRY OUT TO UNLOCKVERIFY GASKET IS SEATED IN FEMALE END OF PIPEMALE ENDFEMALE ENDFigure 3APPLIANCE CONNECTION: 2" - 4&

INSTALLATION1. Pipe lengths may be cut to length (Fig.6). Use an alternate clamp (Fig.4- PPS-PAC / PPS-LBC) for the connection if a locking button (

8Multi-Story: Consult local building or other applicable codes for requirements in your area. In the U.S., NFPA 211 10.6.3 (2013) states: “Vents th

97. Add additional components to raise vent level if desired (vent to be 12" above grade or average snow level).8. Remove gasket and install Bi